Volume/Pan Settings For Each Part [F4 (Mixer)]; Effect Settings For Backing Parts [F5 (Rev/Cho)] - Roland V-Drums TD-20 Owner's Manual

Volume/Pan Settings for Each Part
[F4 (MIXER)]
* Drum part cannot be set here. Set in the MIXER settings (p.
37).
* To adjust volume/pan settings for each instrument of the
percussion part, refer to p. 55.
1. Press [PATTERN] - [F2 (PART)].
The "PATTERN PART" screen appears.
2. Press [F4 (MIXER)].
The "PART VOLUME", "PART PAN", "PART REVERB
SEND LEVEL", or "PART CHORUS SEND LEVEL"
screen appears.
fig.06-Mixer_70
3. Press [F1]–[F4] to select the parameter.
4. Press [CURSOR (left/right)] to select the part
you wish to set.
5. Use [+/-], [VALUE], or [CURSOR (up/down)] to
make settings.
Parameter
[F1 (VOLUME)]
PART VOLUME
[F2 (PAN)]
PART PAN
[F3 (REV SND)]
PART REVERB SEND LEVEL
[F4 (CHO SND)]
PART CHORUS SEND LEVEL
Value
0–127
L15–CTR–R15
0–127
0–127
Chapter 6. Sequencer (Playback)
Effect Settings for Backing Parts [F5
(REV/CHO)]
Set the amount of reverb and chorus for each backing part.
1. Press [PATTERN] - [F2 (PART)].
The "PATTERN PART" screen appears.
2. Press [F5 (REV/CHO)].
The "REVERB/CHORUS" screen appears.
fig.06-RevCho_70
3. Press [CURSOR] to select the parameter.
4. Use [+/-] or [VALUE] to make settings.
5. Press [F1] and/or [F5] to turn the reverb/chorus
ON or OFF.
[F1]: Reverb On/Off
[F5]: Chorus On/Off
Parameter Value
REVERB
Type ROOM1,
ROOM2,
STAGE1,
STAGE2,
HALL1, HALL2,
DELAY, PAN-
DELAY
Time 0–127
CHORUS
Type TYPE1–3
Rate 1–64
Depth 1–64
Description
Type of reverb
Reverb Length/
Delay Time
Type of chorus
Speed of modu-
lation
Depth of modu-
lation
57