Roland TD-20 Supplementary Manual

Cautions When Mounting the
Percussion Sound Module on the Stand
When attaching the stand holder (included with the optional drum stand) to the
percussion sound module, use the screws attached to the bottom panel and attach the
holder so the unit is oriented as shown in the diagram.
ONLY use the screws provided with the percussion sound
module. Other screws may damage the unit.
fig.StandHolder.e
928, 929
• When turning the unit upside-down, get a bunch of newspapers or magazines, and place them
under the four corners or at both ends to prevent damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or controls get damaged.
• When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or
tip over.
202
TD LEAFLET SCREW
Narrow
Copyright © 2005 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in
any form without the written permission of ROLAND CORPORATION.
* 4
Screws provided with the
percussion sound module
0 6 7 3 6 0 1 -
Wide
0 1 *
40673601 1PD