Master Effect Mode [F2 (Comp/Eq)]; Adjusting The Display Contrast [F5 (Lcd)]; Restoring The Factory Settings [F5 (F Reset)] - Roland V-DRUMS TD-20 Owner's Manual

Master Effect Mode [F2 (COMP/EQ)]

You can specify which is used for the master effect (p. 43),
individual settings for each drum kit or common settings to all
kits.
1. Press [SETUP].
[SETUP] lights.
2. Press [F4 (OPTION)] - [F2 (COMP/EQ)].
The "MASTER COMP/EQ MODE" screen appears.
fig.10-Master_70
3. Use [+/-] or [VALUE] to make settings.
INDIVIDUAL: Master effect for each kit, individually.
Master effect common to other drum kits is
GLOBAL:
used.
When this is set to "GLOBAL," "GLOBAL" appears on the
icon at the left part of the master effect setting screen.
fig.10-Master2_70
Adjusting the Display Contrast
[F5 (LCD)]
The display contrast is strongly influenced by the location of
the TD-20 and the lighting of the room it's in. Adjust this
parameter when needed.
1. Press [SETUP].
[SETUP] lights.
2. Press [F4 (OPTION)] - [F5 (LCD)].
The "LCD CONTRAST" screen appears.
fig.10-Display_70
3. Use [+/-] or [VALUE] to adjust.
* You can also adjust it by holding [KIT] and turning [VALUE].
Chapter 10. Settings for the Entire TD-20 [SETUP]
Restoring the Factory
Settings [F5 (F RESET)]
This restores the TD-20 to the original factory settings
(Factory Reset).
All data and settings stored in the TD-20 are lost in
carrying out this operation. So if necessary, save your
data to a memory card or an external MIDI device before
executing the factory reset (p. 70, p. 77).
1. Press [SETUP] - [F5 (F RESET)].
[SETUP] lights, and the "FACTORY RESET" screen
appears.
fig.10-Factory1_70
2. Press [F5 (RESET)].
The confirmation screen appears.
fig.10-Factory2_70
* To cancel, press [F1 (CANCEL)].
3. Press [F5 (EXECUTE)] to execute Factory
Reset.
When Factory Reset is finished, the "DRUM KIT" screen
appears.
When Factory Reset is carried out, the [GROUP FADERS]
settings values are set to the maximum volume,
regardless of the slider positions.
81