Other Useful Functions; Returning To The Basic Sound; By Removing Effects; Calling The Factory Preset - Roland DDR-30 Owner's Manual

4. Other Useful Functions
a. Returning to the Basic Sound by
Removing Effects
The preprogrammed drum sounds of the DDR-30
take on various effects such as Pitch Bend,
Equalizer and Gate, etc. The DDR-30, however,
features the function to remove all these effects
and return to the basic sound without any effect.
This function is useful when you particularly want
the basic sound for editing from the beginning.
OPERATION
@ Call the drum sound from which you wish to
remove all the effects applied, by using the
Instrument Button @ and Patch Number But-
ton @.
@ Hold the Voice Button @ down for about four
seconds.
The Display shows Edit mode indication
(SOURCE No. ) for a few seconds then returns
to the usual indication. This means that the Basic
sound has replaced the drum sound you called in
the step (7).
(DCall the drum sound.
(Hold the Voice Switch Ө down
for about 4 seconds.
b. Calling the Factory Preset
In the memory of the DDR-30, 32 Drum Set com-
binations are preprogrammed. We call the entire
data "Factory Preset", and this can be recalled at
any time by a simple operation.
As you write an edited sound or new combination
of Drum Set, the preprogrammed sound or Drum
Set of the Factory Preset will be inevitably erased.
Later, however, you may want to call back the
Factory Preset in its complete from. If so, take the
following operation.
OPERATION
© Turn the DDR-30 off.
(2) While holding the Set Switch [1] down, turn
the unit on.
* This operation recalls the whole Factory Preset,
but the data you have programmed previously
will be all erased. If you wish to retain the
programmed data, save it to the Memory Car-
tridge as instructed on page 20 before calling
the Factory Preset.
In the step @, by pressing the button of [2] [3] or
[4] instead of [1], a part of Factory Preset can be
recalled as shown below, the irrelevant part of the
Internal memory will remain intact.
[2]: Drum Set Combination and all the Parameter
Data except the sensitivity and MIDI
[3]: Sensitivity Data
[3]: MIDI Data
Roland
п WERE
= (AIO
While holding this Button down ---
powtn
7
Power ОМ х
21