Selecting The Input Video Signal; (Video In); Selecting The Reference Signal; (Out Ref) - Sony DVW-A500P/1 Operation Manual

4-5 PF1 Menu (Factory Settings)
4-5-1 Selecting the Input Video
Signal (VIDEO IN)
Press the [F1] (VIDEO IN) button repeatedly to select
the video signal to input.
sif: Serial digital video signal input to the SERIAL V/
A INPUT connector
cmpst: Analog composite video signal input to the
COMPOSITE VIDEO INPUT connector
y-r/b: Analog component video signal input to the
COMPONENT VIDEO INPUT connectors
4-5-2 Selecting the Reference
Signal (OUT REF)
Press the [F2] (OUT REF) button to select the signal to
be used as the reference signal for VTR operations.
ref: The signal input to the REF.VIDEO INPUT
connector is used as the reference signal for
playback and audio recording. Digital audio and
video input signals must synchronize with this
reference signal during recording.
input: The video input signal is used as the reference
signal for VTR operations. The [F1] (VIDEO IN)
button switches the video input signal.
4-5-3 Switching the Control of
the Digital Video Processor

(PROC CONTRL)

Press the [F3] (PROC CONTRL) button to select the
method for operating the internal digital video
processor.
menu: Select this setting when adjusting the settings
of the internal digital video processor through the
PF1 menu or items 715 to 721 of the VTR SETUP
menu.
local: Select this setting when controlling the
internal digital processor from the control panel of
the VTR.
rmt: Select this setting when using the optional
BVR-50 Remote Controller to remotely control
the internal digital video processor.
For details on items 715 to 721 of the VTR SETUP menu,
refer to Menu List on page A-28.
4-34
Chapter 4 Menu Settings
Note
Changing the PROC CONTRL setting during playback
may cause a momentary interruption in the sound
output.
4-5-4 Adjusting the Output Video
Signal (VIDEO GAIN to SYSTEM
SC)
Adjusting the output video signal
Follow the procedure below to adjust the output video
signal.
1,3 1,3
Adjusting the output video signal
1
Press the function button ([F4] to [F10]) whose
setting you wish to set.
The setting display section lights up.
2
Change the numerical value by pressing the G or
g button (or + or – button).
To change the value quickly, press the buttons
while holding down the SFT button.
To set the preset value
Press the center cursor button.
PRST appears over the respective function button.
3
Press the function button after adjusting the
numerical value.
2