Brother HL-L3230CDW Online User's Manual page 89

• If you selected the [WPA/WPA2-PSK] option, press a or b to select the Encryption Type [TKIP+AES] or
[AES], and then press OK.
™
Enter the WPA
Your Brother machine supports the use of the first WEP key only.
11. To apply the settings, select [Yes].
12. The machine will attempt to connect to the wireless device you have selected.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
You have completed the wireless network setup. To install the Full Driver & Software Package necessary for
operating your machine, insert the Brother installation disc into your computer, or go to your model's Downloads
page on the Brother Solutions Center at support.brother.com.
HL-L3270CDW
Before configuring your machine, we recommend writing down your wireless network settings. You will need
this information before you continue with the configuration.
1. Check and write down the current wireless network settings.
Network Name (SSID)
Communication Mode
Infrastructure
For example:
Network Name (SSID)
HELLO
Communication Mode
Infrastructure
If your router uses WEP encryption, enter the key used as the first WEP key. Your Brother machine
supports the use of the first WEP key only.
2. Press [Settings] > [All Settings] > [Network] > [WLAN] > [Setup Wizard].
3. When [Enable WLAN?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
4. The machine will search for your network and display a list of available SSIDs. Press a or b to display the
[<New SSID>] option.
5. Press [<New SSID>], and then press [OK].
6. Enter the SSID name, and then press [OK].
7. Press [Infrastructure] when instructed.
8. Select the Authentication Method.
9. Do one of the following:
key, and then press OK.
Authentication Method
Open System
Shared Key
WPA/WPA2-PSK
Authentication Method
WPA2-PSK
Encryption Mode
NONE
WEP
WEP
AES
TKIP
Encryption Mode
AES
Network Key
-
Network Key
12345678
84