Brother HL-L3230CDW Online User's Manual page 326

Level 1 Level 2
Wi-Fi Status Info.
Direct
I/F Enable
Network -
Reset
1 On connection to the network, if the machine's 'Boot Method' is 'Auto' the machine will attempt to set the IP address and Subnet Mask
from a boot server such as DHCP. If a boot server cannot be found, an APIPA IP address will be allocated, such as 169. 254. [001-254].
[000-255]. If the 'Boot Method' of the machine is set to 'Static', you must manually enter an IP address from the machine's control panel.
[Print Reports]
Level 1
Printer Settings
Network Config
Print File List
(Available only for certain models)
Drum Dot Print
WLAN Report
(For wireless models)
[Machine Info.]
Level 1 Level 2
Serial No. -
Firmware Version -
Page Counter -
1 Toner
Parts Life
Drum
Belt
Fuser
PF Kit 1 Display the remaining life of the PF Kit 1.
1 Life is approximate and may vary by type of use.
[Initial Setup]
Level 1 Level 2
Reset Machine Reset Restore all the machine settings that you have changed.
Network Reset Restore all network settings back to the factory settings.
Factory Reset Restores all the machine's settings to the factory defaults. Perform this
Local Language -
Level 3 Level 4
Signal -
Channel -
Speed -
- -
- -
Level 2 Description
- Print the Printer Settings page.
- Print the Network Configuration Report.
- Print a list of data saved in the memory.
- Print the Drum Dot Check Sheet.
- Print the wireless LAN connectivity diagnosis result.
Description
Display the machine's serial number.
Check your machine's firmware version.
Display the total printed pages.
Display the remaining life of each toner.
Display the remaining life of each drum unit.
Display the remaining life of the belt unit.
Display the remaining life of the fuser unit.
Description
operation when you dispose of your machine.
Select the LCD language for your country.
Descriptions
Display the current Wi-Fi Direct network signal
strength.
When your machine acts as Group Owner, the
LCD always displays Strong.
Display the channel in use when the Status is
G/O Active or Client Active.
Display the connection speed when the Status is
G/O Active or Client Active.
Enable or disable the Wi-Fi Direct connection.
Restore all network settings of your machine to the
factory settings.
321