Support Information; Diagnostic Test 3 – Calibrate Lift Home; Diagnostic Test 5 – Cycle The Lift - Rimage Amigo II Supplementary Manual

Diagnostic Test 3 – Calibrate Lift Home
This diagnostic test calibrates the Lift Arm so that it accurately detects the number of discs in the bins. This
calibration counts the correct number of motor steps between the Lift Arm home position and the last disc in the
carousel. If the lift arm incorrectly determines the number of discs in the bin, does not pick the last disc in the bin,
or drops the CDs into the recorder or printer from an incorrect height, it may need to be calibrated.
Tip: This diagnostic test uses the Carousel Motor, Lift Motor, Carousel Sensor, and the Lift Home Sensor.
1. Place a disc in Bin 1.
Important: Make sure there is only one disc in Bin 1.
2. Access and select diagnostic
calibrates. When the test is finished, calibration information is stored in the FLASH. The autoloader
restarts and exits the diagnostic tests mode.
Note: The Active LED will not illuminate when this test begins.
Diagnostic Test 5 – Cycle the Lift
This diagnostic test cycles media between the carousel bins and the printer, looking for an index mark each
cycle.
Important: Use a disc with an index mark.
Tip: This diagnostic test uses the Lift Motor, printer, Rotate Motor, the carousel, Carousel Sensors, Index
Sensor, and the Media Sensor.
1. Place one or more discs with an index mark in any bin.
2. Access and select diagnostic
3. To stop the test, press the Operator Button.
Note: The test will continue to cycle media until you stop it.
4. To exit diagnostic tests, see

Support information

Europe
Contact Rimage Services Europe:
www.rimage.com/support.html
Email: support@rimage.de
Tel: +49-(0) 6074-8521-0
US, Asia/Pacific, Mexico/Latin America
Contact Rimage Services:
www.rimage.com/support.html
Email: http://www.rimage.com/support_form.cfm
Tel: North America: 800-553-8312
Asia/Pacific, Mexico/ Latin America: 952-946-0004
2
tests. See page 1. The Lift Arm picks up the disc, drops the disc, and
tests. See page 1.
Exiting Diagnostic tests on page 2.
When you contact Rimage Services, please provide:
• Unit serial number and software version.
• Functional and technical description of the problem.
• Exact error message received.
Rimage Corporation reserves the right to make improvements to
the equipment and software described in this document at any time
without any prior notice. Rimage Corporation reserves the right to
revise this publication and to make changes from time to time in
the content hereof without obligation of Rimage Corporation to
notify any person or organization of such revisions or changes.
Diagnostic Tests