Ethernet Configuration - Ricoh AP2610 Setup Manual

3. Configuring the Printer for
Make the network settings below depending on the network interface you use.
• Parallel/USB: Making network settings is not necessary. Go to p.51 "Install-
ing the Printer Driver and Software".
• Ethernet: Make the settings in p.41 "Ethernet Configuration", and then see
p.51 "Installing the Printer Driver and Software".
• IEEE 1394: Make the settings in p.45 "IEEE 1394 Configuration", and then see
p.51 "Installing the Printer Driver and Software".
• Wireless LAN: Make the settings in p.48 "IEEE 802.11b (Wireless LAN) Con-
figuration", and then see p.51 "Installing the Printer Driver and Software".
Note
❒ The optional Network Interface Board is necessary to use Ethernet with Basic
model printer.
❒ The optional 1394 Interface Unit is necessary to use IEEE 1394.
❒ The optional 802.11b Interface Unit is necessary to use the wireless LAN.

Ethernet Configuration

Configure the printer for the network
using the printer's control panel.
The following table shows the control
panel settings and their default val-
ues. These items are included in the
"Host Interface" menu.
Reference
For information about configuring
the computer for the network, see
the Network Printing Guide on the
CD-ROM labeled "Operating In-
structions".
For information about "Host Inter-
face" menu, see "Host Interface
Menu" in the Printer Reference on
the CD-ROM labeled "Operating
Instructions".
the Network
Setting Name
IP Address
Subnet Mask
Gateway Address
Network Boot
Frame Type (NW)
(Frame type NetWare)
Active Protocol
*2
Ethernet
*3
LAN Type
❍ means that this protocol is active.
*1
*2
Make this setting only when it is nec-
essary.
*3
Appears only when both the Network
Interface Board and the 802.11b Inter-
face Unit are installed.
Value
011.022.033.044
000.000.000.000
000.000.000.000
None
Auto
❍
*1
TCP/IP
❍
*1
NetWare
❍
*1
NetBEUI
❍
*1
AppleTalk
Auto
Ethernet
41