Ieee 1394 Configuration - Ricoh AP2610 Setup Manual

IEEE 1394 Configuration

Use this procedure to configure the
printer for use in the IEEE 1394 envi-
ronment. The following table shows
the control panel settings and their
default values. These items are in-
cluded in the "Host Interface" menu.
Setting Name
IP Address1394
Subnet Mask1394
IP over 1394
SCSI print
Bidi-SCSI print
Depending on the protocol you use,
procedures vary. See the following ta-
ble.
IP over 1394
SCSI print
A A A A
Press { { { { Menu} } } } .
Menu
On Line
Job Reset Escape
Form Feed Enter
Power Error
"Menu" appears on the panel dis-
play.
B B B B
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "Host
Interface" menu.
Menu:
Host Interface
Value
000.000.000.000
000.000.000.000
Active
Active
Active
Steps A-H and then
go to steps M to N
Steps A-D and then
go to steps I to N
Data In
ZFDP020N
C C C C
Press { { { { Enter #} } } } .
Menu
On Line
Job Reset Escape
Form Feed Enter
Power Error
The following message appears on
the panel display.
Host Interface:
I/O Buffer
D D D D
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "IEEE
1394 Setup".
Host Interface:
IEEE 1394 Setup
E E E E
Press { { { { Enter #} } } } .
The following message appears on
the panel display.
IEEE 1394 Setup:
IP Address1394
F F F F
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "IP
over 1394".
IEEE 1394 Setup:
IP over 1394
A Press { { { { Enter #} } } } .
B Press { { { { U U U U } } } } or { { { { T T T T } } } } to select ei-
ther "Active" or "Not Active".
C Press { { { { Enter #} } } } .
The display returns to the previ-
ous menu in a few seconds.
IEEE 1394 Configuration
Data In
ZFDP060N
3
45