Paper Feed Unit Type 2600 - Ricoh AP2610 Setup Manual

Paper Feed Unit Type 2600

Important
❒ Do not slide more than one paper
tray out at the same time. Having
more than one paper tray filled
with paper in a fully extended po-
sition could cause the machine to
fall down.
❒ Do not attach more than two Paper
Feed Units in your printer at the
same time.
❒ Check the printer nameplate to
confirm the model code.
A A A A
Check the contents of the box for
the following items:
• Paper Feed Unit (including a
paper tray)
• Installation Guide
B B B B
Confirm that the followings are
true:
• The power switch is turned off.
• The power cord is unplugged
from the wall outlet.
C C C C
Remove the adhesive tape from
the Paper Feed Unit.
Note
❒ If you attach two Paper Feed
Units at the same time, stack
them up in advance.
D D D D
There are three pins on the top of
the Paper Feed Unit that point
straight up. On the bottom of the
printer there are three holes.
Align the holes over the pins, and
then lower the printer gently onto
the Paper Feed Unit.
R CAUTION:
• When lifting the machine, use
the inset grips on both sides.
Otherwise the printer could
break or cause injury if dropped.
E E E E
Attach the interface cable to the
printer.
ZCEX390J
Paper Feed Unit Type 2600
ZGDX400J
ZGDH052N
2
15