Ricoh AP2610 Setup Manual page 35

K K K K
Match the controller board to the
top and bottom rail using the "T T T T "
mark, and then slide it into the
printer slowly until it stops.
L L L L
Push back the handle of the con-
troller board until it clicks.
M M M M
Fasten the controller board to the
printer with the two screws.
Note
❒ If the Duplex Unit is not at-
tached, go to step
N N N N
ZGDX253J
O O O O
ZGDX380J
ZGDX271J
O
.
Network Interface Board Type 2610
While aligning the power cord to
the left side groove of the Duplex
Unit, slide the Duplex Unit in un-
til it is connected to the printer.
Plug the printer's power cord
back into the wall outlet, and then
turn on the power switch.
2
ZGDX241J
23