Ricoh AP2610 Setup Manual page 42

Installing Options
G G G G
Place the controller board on a flat
surface.
H H H H
Use a coin to remove the two
screws, and then remove the cov-
er.
Note
2
❒ These screws are used again in
J
step
I I I I
Attach the 802.11b Interface Unit.
Insert the end of the 802.11b Inter-
face Unit into the opening (A), and
then push down until it clicks (B).
30
.
J J J J
Fasten the 802.11b Interface Unit
to the controller board with the
two screws.
K K K K
Insert the card slowly into the
802.11b board with the label fac-
ing down and the uneven black
antenna surface facing up until it
stops.
ZGDX410J
L L L L
Match the controller board to the
top and bottom rail using the "T T T T "
mark, and then slide it into the
printer slowly until it stops.
ZGDX420J
ZGDX431J
ZGDX442J
ZGDX500J
ZGDX251J