Additional Copy - Ricoh Aficio 240W Copy Reference Manual

• When the "
Please
message is displayed (such as
when the machine is warming
up).

Additional Copy

You can make additional copies after
you have finished copying until Cop-
ier Auto Reset. You can make addi-
tional copies using previous settings
and the scanned original's image
saved in machine memory. Making
changes to settings as required, and
then press the { { { { Start} } } } key.
Note
❒ You can change the following
functions when using Additional
Copy.
• Number of copies
• Paper tray selection
• Fine Magnification
• Shift
• Margin
• Erase Border
• Double Copies
• Upper output/Lower output
• Paper cut method
• Interrupt Copy
• Print function (only when se-
lected in the original settings)
❒ If paper roll tray 1, 2, or the cut pa-
per tray was selected as the paper
source in the original settings, you
cannot select the bypass tray.
❒ If you make a mistake when enter-
ing the settings, press the function
key again or [Cancel] to clear them.
If you press the { { { { Clear Modes} } } } key,
you can delete the scanned origi-
nal's image from memory.
A A A A
"
wait.
Press the { { { { Start} } } } key.
Fine Directional Magnification
(Additional Copies Only)
Paper can expand or shrink, resulting
in original and copy size not match-
ing (such as under humid condi-
t i o n s ) . T h i s f u n c t i o n u s e s t h e
measurements of the original and
copy to calculate a ratio to produce
copies close to actual size.
Note
❒ Fine Directional Magnification is
used for originals that have al-
ready been scanned. To perform
fine magnification corrections for
paper that has expanded due to its
type or exposure to humidity, set
"Fine Ratio:Copier" in System Set-
tings. See "User Tools (System Set-
tings)", General Settings Guide.
❒ Set the correction ratio after meas-
uring the length and width of the
original and copy.
Calculating the Correction Value (%)
Example)
To copy at the same size as the original
... For the example above:
Set the correction value (horizontal) to 0.8%.
Basic Procedure
Original Copy
Horiz. Horiz.
correction value(%)
DRAFT 2003/11/12
2
ZEDG010E
21