Setting The Carrier Sheet - Ricoh Aficio 240W Copy Reference Manual

❒ When inserting thick paper,
push it lightly against the roller.
Pushing it with force may cause
a paper jam.
❒ When inserting originals, be
careful not to put the trailing
edge into the entrance of the by-
pass tray. This will cause a pa-
per jam.
Note
❒ Do not release your hands until
the original is pulled in. Release
when it has gone slightly in.
❒ You can change the original
feed delay setting if originals
are repeatedly feeding in slant-
ed, or if you need to adjust the
delay for the type of originals
you are using. See "Orig. Feed
Delay1", General Settings Guide.
- To stop originals feeding in -
- -
If the originals are feeding in slanted,
or jamming, etc., press the { { { { Scanner
Stop} } } } key to stop them feeding in.
Note
❒ When you press the { { { { Scanner Stop} } } }
key, the original stops immediate-
ly, which can cause it to jam. When
this happens, see "xClearing Mis-
feeds", General Settings Guide.
❒ When you have set original rear
output as the original output loca-
tion, the rear edge of the originals
are held at the output exit. To can-
cel this, press the { { { { Scanner Stop} } } }
key. See p.9 "Original Output Lo-
cations".

Setting the Carrier Sheet

Important
❒ When using the optional carrier
sheet, set the original output loca-
tion to rear original output. If the
original output location is set to
original upper output, the original
may be damaged.
Note
❒ When using the carrier sheet with
Synchro Cut selected, the paper is
cut to the size of the carrier sheet.
Reference
For details about using the carrier
sheet to make copies, see p.13
"Originals that should be scanned
using the carrier sheet".
A A A A
Open the carrier sheet with the
transparent sheet face up, and
then insert the original also face
up.
ABB542S
Placing Originals
DRAFT 2003/11/12
1
ZEDP020E
17