Cisco Aironet 1130AG Series Hardware Installation Manual page 53

2-22 2-22
Chapter 2 2 Chapter Installing the Installing
Connecting to an Ethernet Network with an Inline Power Source Connecting to an Ethernet Network with an
Caution Caution
Note Note
St Step ep 1 1
St Step ep 2 2
St Step ep 3 3
St Step ep 4 4
St Step ep 5 5
St Step ep 6 6
the Access Access Point Point
Be careful when handling the access point; the bottom plate might be hot. Be careful when handling the access point; the bottom plate might be hot.
If your access point is conn ected to in-line power, do not connect the power modu If your access point is conn
Using two power sources on the access point might cause the access point to shut down to protect internal Using two power sources on the access point might cause the access point to shut down to protect internal
components and might cause the switch to shut down the port to which the access point is connected. If components and might cause the switch to shut down the port to which the access point is connected. If
your access point shuts down, you must remove all power and reconnect only a single power source. your access point shuts down, you must remove all power and reconnect only a single power source.
Follow these steps to connect the access point to the Ethernet LAN when you have an inline power Follow these steps to connect the access point to the Ethernet LAN when you have an inline power
source: source:
If necessary, open the access point cover (see the "Opening the Access Point Cover" section on If necessary, open the access point cover (see the
page pag e 2-1 2-11 1 ). ).
Pull the Category 5 Ethernet cable out of the access point cable bay area approximately 1 foot. Pull the Category 5 Ethernet cable out of the access point cable bay area approximately 1 foot.
Loop the cable back towards the Ethernet connector (see Figu Loop the cable back towards the Ethernet connector (see
F F i i g g u u r r e e 2 2 - - 1 1 5 5 L L o o o o p p i i n n g t g th h e E
Connect the Ethernet cable to the RJ-45 Ethernet connector labeled Connect the Ethernet cable to the RJ-45 Ethernet connector labeled Ethe
Push or pull the excess cable length (the loop) back through the access point cable bay area. Push or pull the excess cable length (the loop) back through the access point cable bay area.
Close the access point cover by sliding it over the cable bay area until you hear a click. Close the access point cover by sliding it over the cable bay area until you hear a click.
Inline Power Source
ected to in-line power, do not connect the power modu le to the access point.
"Opening the Access Point Cover" section on
e Et t h h e e r r n n e e t C t Ca a b b l l e e
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide Cisco Aironet 1130AG Series Access
Connecting the Ethernet and Power Cables Connecting the Ethernet and Power Cables
le to the access point.
Figure re 2-15) ) 2-15
1 1
1 1
7 7
1 1
2 2
1 1
Ethernet rnet on the access point. on the access point.
Point Hardware Installation Guide
OL-8369-04 OL-8369-04