Cisco Aironet 1130AG Series Hardware Installation Manual page 43

2-12 2-12
Chapter 2 2 Chapter Installing the Installing
St Step ep 2 2
St Step ep 3 3
St Step ep 4 4
St Step ep 5 5
St Step ep 6 6
the Access Access Point Point
Drill a 3/16 in. (4.7 mm) hole at the X mounting hole locations you marked. Drill a 3/16 in. (4.7 mm) hole at the X mounting hole locations you marked.
Insert the wall anchors into the mounting holes. Insert the wall anchors into the mounting holes.
If needed, drill or cut a cable access ho le (see If needed, drill or cut a cable access ho
power cables and pull the cables through the access hole until you have about 1 foot of exposed cables power cables and pull the cables through the access hole until you have about 1 foot of exposed cables
protruding from the hole. protruding from the hole.
Note Note
You can optionally insert the Ethernet cable and the power cable (if used) through the cable You can optionally insert the Ethernet cable and the power cable (if used) through the cable
access notch in access point housing (see access notch in access point housing (see Fi Figur
Position the mounting plate over the wall anchors or the drilled holes. Position the mounting plate over the wall anchors or the drilled holes.
Insert two 8 x 32 x 1 inch pan head screws in the X mounting holes and tighten. Insert two 8 x 32 x 1 inch pan head screws in the X mounting holes and tighten.
To attach the access point to the mounting plate, see To attach the access point to the mounting plate, see "
sect section on pag ion on page e 2-17. . 2-17
Mounting the Access Point on a Horizontal or Vertical Surface Mounting the Access Point on a
le (see Fi Figur gure e 2- 2-6 6 ) large enough for the Ethernet and possibly the ) large enough for the Ethernet and possibly the
gure e 2-5). ). 2-5
" Attaching the Access Point to the Moun Attaching the Access Point to the Moun
Cisco Aironet 1130AG Series Access Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-8369-04 OL-8369-04
Horizontal or Vertical Surface
Point Hardware Installation Guide
ting Plate" ting Plate"