Table of Contents
Advertisement
■
Release the ZIF connector (1) the fingerprint reader cable is connected to, and then disconnect the
cable (2) from the fingerprint reader.
To install the fingerprint reader cable, reverse this procedure.
Power connector cable
To remove the power connector cable, use this procedure and illustration.
Table 5-15
Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the fan (see
5.
Remove the system board (see
Remove the power connector cable:
Bottom cover on page
Battery on page
35).
Fan on page
48).
System board on page
Preparation for disassembly on page
34).
52).
Spare part number
M03424-001
34).
Power connector cable
57
Advertisement
Table of Contents
