Table of Contents
Advertisement
3.
Remove the two M2.0 × 2.0 screws (2) that secure the top-cover camera and bracket to the
computer.
4.
Remove the top-cover camera bracket (3) from the computer.
5.
Remove the top-cover camera (4) from the computer.
To install the top-cover camera, reverse this procedure.
Top-cover camera-board cable
To remove the top-cover camera-board cable, use this procedure and illustration.
NOTE:
The top-cover camera-board cable is included in the Cable Kit, spare part number M03431-001.
Before removing the top-cover camera-board cable, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the top-cover camera-board cable:
1.
Release the ZIF connector (1) the top-cover camera-board cable is connected to, and then
disconnect the cable from the system board.
2.
Release the ZIF connector (2) the top-cover camera-board cable is connected to, and then
disconnect the cable from the top cover camera board.
40
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page
35).
34).
34).
Advertisement
Table of Contents
