Chapter 2: Installation
2. Secure the assembly with the split pin (supplied).
3. Install the adaptor pin bracket to the cable end sheath.
Note: The adaptor pin bracket must sit against, but not on, the shoulder of
the cable end sheath. Also, it is important that the securing bolts are
sternside of the steering cable end sheath.
4. Ensure that the bracket remains vertical and tighten the locking bolts.
5. Rotate the girdle support bracket so that locator pin is facing
forwards.
6. Position the stern drive actuator so as to locate the fixed support pin
on the girdle support bracket into the hole in the girdle tube.
Girdle support
bracket
Tiller end block
Split pin
Adaptor
bracket
Aft
Cable end
sheath
Shoulder
59
D745-1
D925-1