Type 2 Drive Unit (24V); Stern Drive Actuator; Mounting; Volvo (Pre Type 872215) - Raymarine Autohelm 100 Install Manual

56

Type 2 Drive Unit (24V)

Stern drive Actuator

Mounting

Volvo (Pre type 872215)

Cable Length (Drive Unit
to Course Computer)
Up to 3m (10ft)
Up to 5m (16ft)
Up to 7m (23ft)
Up to 10m (32ft)
Up to 16m (52ft)
The stern drive actuator can be fitted to power assisted Stern drive
systems made by Volvo-Penta, Mercruiser, OMC and Yamaha. Different
installation kits are available to cover most of these installations.
Note: Older Volvo steering systems (Pre type 872215) require an adaptor
bracket (D129).
Fitting to this type of engine requires an adaptor bracket (M81139).
The stern drive actuator should be connected to the centre hole on the
tiller arm. On twin engine installations, this is the position used to connect
the engine tie bar to link the two tiller arms.
Mounting
bracket
Hexagonal
Spring
key bolt
washer (2 off)
(2 off)
TYPE 100/300 Operation and Installation Handbook
Cable Gauge
12 AWG
10 AWG
8 AWG
6 AWG
4 AWG
Adaptor pin
(Multi-engine mount)
Small
spring
clip
Bracket Location
clamp pin
Copper Area
2.5 mm
4 mm
6 mm
10 mm
16 mm
Adaptor pin
(Single engine mount)
Split pin
Nyloc nut
81004-05
D768-1