To Remove The Lh Oven Bottom And Top Elements; To Replace The Ceramic Hob Glass; To Replace A Hob Element; To Change Oven Light Bulb - Rangemaster Classic 110 Deluxe Duel Fuel Users Manual & Installation

23. To Remove the LH Oven Bottom and Top
Elements
Disconnect from the electricity supply.
Bottom Element
Pull the cooker forward to access the cover boxes at the
rear of the unit. Remove the fi xings that secure the cover
and lift it clear.
Remove the 2 screws 'A' and allow the plate to drop
down. Remove the 2 screws B, lower the upper plate and
remove through the slot in the cooker back.
Undo the terminal connections, noting their positions.
Remove the element fi xings and withdraw element.
Replace the element and re-assemble parts in reverse
order.
Top Element
Open the LH oven door and undo the fi xings that secure
the heat shield. Remove the top element bracket fi xings
and withdraw element. Replace the element and re-
assemble parts in reverse order. Check that the oven
operates satisfactorily.

24. To Replace the ceramic hob glass.

Remove the hotplate, see 2. Fit the replacement hotplate
and ceramic hob.
Reassemble in reverse order. Check operation of the
ceramic hob.

25. To Replace a Hob Element.

Remove the hotplate, see 2. The elements are now
accessible.
Reassemble in reverse order. Check operation of the
ceramic hob.

26. To change oven light bulb.

Turn off the power supply.
Make sure the oven is cool. Open the oven door and
remove the oven shelves.
Unscrew the bulb cover by turning anticlockwise. It may
be very stiff .
Taking care to protect your fi ngers in case the bulb
should shatter, unscrew the old bulb.
Fit an Edison screw fi tting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C.
Screw in the new bulb, screw back the bulb cover. Turn
on the electricity supply and check that the bulb now
lights.

27 To Adjust the Oven Door Angle

The door bottom hinge can be adjusted to alter the
angle of the door.
Loosen the bottom hinge fi xing screws and use the
notch and a fl at bladed screwdriver to move the position
of the hinge to set the hinge position.
Retighten the hinge screws.
Eff ect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
38