Ceramic Hob - Rangemaster Classic 110 Deluxe Duel Fuel Users Manual & Installation

To fi t the small inner burner, fi nd the larger electrode
notch in the burner rim. Line this up with the white
ignition electrode and place the inner burner on the
large base ring.
A electrode notch
Now fi t the two burner caps, making sure that they
are sitting down properly.

Ceramic Hob

It's very easy to clean the Hob with a recommended
cleaner.
CAUTION — Do not use abrasive cleaners or pads,
oven aerosols or pads or stain removers on the
surface.
Daily care
First of all, be sure that the heat indicator light is off
and the cooking surface is cool. Apply a small dab,
about the size of a 10p piece, of ceramic cooking
cleaning cream in the centre of the area to be
cleaned. Dampen a clean paper towel and work the
cleaning cream on the cooking surface as if you were
cleaning a window. As a fi nal step, wipe the cooking
surface with a clean, dry paper towel.
Cleaning for spills
For spills and boil-overs that occur while cooking,
turn the unit off and wipe the area surrounding the
hot zone with a clean paper towel. If a spill (other
than a sugary substance) is on the hot zone, do not
clean until the unit is completely cooled down and
follow the instructions below ("Cleaning for burned-
on spills"). If you accidentally melt anything on the
cooking or if you spill foods with a high sugar content
(preserves, tomato sauce, etc.), REMOVE the spill
IMMEDIATELY with a razor scraper, while the hob is
still hot. IMPORTANT: Use an oven glove to protect
your hand from potential burns. Scrape the major spill
or melted material from the cooking zone and push
into a cold area. Then, turn the unit "OFF" and allow to
cool before cleaning further. After the cooking surface
cools down and the heat indicator lights go off , use
the daily care procedure as outlined above.
B ignition electrode
Cleaning for burned-on spills
Be sure that the heat indicator lights are off and the
hob is cool. Remove excess burned-on substance
with a single-edged razor scraper. Hold the scraper at
approximately a 30° angle to the surface and scrape
off the burned-on matter as you would scrape paint
off of a window.
IMPORTANT: Take care when using a sharp scraper.
When you have removed as much as possible with
the scraper, clean using the daily care procedure as
described above.
To remove metal rub-off
Sliding pans on the hob - especially aluminium or
copper pans can leave marks on the surface. These
marks often appear like scratches, but can be easily
removed using the procedure described above for
cleaning spills. If the rub-off marks are especially
stubborn, use the cleaning cream together with the
razor scraper, using the technique described above.
Glide-out™ Grill
Before you remove any of the grill parts for
cleaning make sure that they are cool.
The grill pan and grid should be washed in hot soapy
water. After grilling meats or any foods that soil, leave
to soak for a few minutes in the sink immediately
after use. Stubborn particles may be removed from
the grid by using a nylon brush. Alternatively the grill
pan can be washed in a dish washer.
To remove the grill pan support frame, pull the grill
pan forward.
Lift the grill pan clear of the support frame.
19