Yamaha FJR13AY 2009 Service Manual page 719

c. Measure the secondary coil resistance.
L LLL L LLL L L LLL L L LLL L
ET3P61015
CHECKING THE IGNITION SPARK GAP
1. Check:
• Ignition spark gap
Out of specification → Perform the ignition
system troubleshooting, starting with step 5.
Refer to "TROUBLESHOOTING" on page
8-10.
Minimum ignition spark gap
6.0 mm (0.24 in)
TIP
If the ignition spark gap is within specification,
the ignition system circuit is operating normally.
M MMM M MMM M M MMM M M MMM M
a. Disconnect the spark plug cap from the spark
plug.
b. Connect the ignition checker "1" as shown.
Ignition checker
90890-06754
Opama pet-4000 spark checker
YM-34487
2. Spark plug cap
c. Turn the main switch to "ON" and engine stop
switch to " ".
d. Measure the ignition spark gap "a".
L LLL L L LLL L LLL
M MMM M M MMM M MMM
8-236
ELECTRICAL COMPONENTS
e. Crank the engine by pushing the start switch
" " and gradually increase the spark gap un-
til a misfire occurs.
L LLL L LLL L L LLL L L LLL L
EAS28120
CHECKING THE CRANKSHAFT POSITION
SENSOR
1. Disconnect:
• Crankshaft position sensor coupler
(from the wire harness)
2. Check:
• Crankshaft position sensor resistance
Out of specification → Replace the crank-
shaft position sensor.
Crankshaft position sensor resis-
tance
421–569 Ω at 20 °C (68 °F)
M MMM M MMM M M MMM M M MMM M
a. Connect the pocket tester (Ω × 100) to the
crankshaft position sensor coupler as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
gray "1"
• Negative tester probe →
black "2"
B
2
b. Measure the crankshaft position sensor re-
sistance.
L LLL L LLL L L LLL L L LLL L
EAS28130
CHECKING THE LEAN ANGLE SENSOR
1. Remove:
• Lean angle sensor
2. Check:
• Lean angle sensor output voltage
Out of specification → Replace.
L LLL L L LLL L LLL
M MMM M M MMM M MMM
Gy
1
L LLL L L LLL L LLL