Yamaha FJR13AY 2009 Service Manual page 157

k. Engage the clutch by turning the manual
clutch operation bolt in direction "b" until it
stops.
TIP
The following illustration shows the manual
clutch operation bolt when viewed from the rear
of the vehicle with the swingarm removed.
l. Repeat steps (i) to (k) until all of the air bub-
bles have disappeared from the clutch fluid in
the plastic hose of the vacuum/pressure
pump gauge set.
m. Tighten the bleed screw to specification.
Bleed screw
6 Nm (0.6 m·kg, 4.3 ft·lb)
n. Manually engage and disengage the clutch
30 times using the manual clutch operation
bolt.
o. Add the recommended clutch fluid to the
proper level.
Refer to "CHECKING THE CLUTCH FLUID
LEVEL (FJR13AE)" on page 3-18.
L LLL L LLL L L LLL L L LLL L
3. Check:
• Pressure plate stroke
M MMM M MMM M M MMM M M MMM M
a. Remove the pickup rotor cover bolts "1".
b. Remove the clutch cover "2".
Refer to "CLUTCH" on page 5-46.
2
c. Manually engage and disengage the clutch
using the clutch operation bolt "3" five times,
each time for less than 1 second.
b a
4
L LLL L L LLL L LLL
M MMM M M MMM M MMM
1
3-20
TIP
Turn the clutch operation bolt in a continuous
motion, without allowing the pressure plate to
stop in mid-stroke.
d. Install a suitable bracket "4", the magnet base
B "5" and the dial gauge & stand set "6".
Magnet base B
90890-06844
Magnetic base stand
YU-A8438
Dial gauge & stand set
90890-01252
6
4
b
c
a
a
a. 100 mm (3.94 in)
b. 20 mm (0.79 in)
c. 1.5 mm (0.06 in)
d. 64 mm (2.52 in)
e. M6 × 40 mm bolt
f. 5 mm (0.20 in)
g. 60 mm (2.36 in)
ENGINE
3
5
d
e
f
g