Yamaha FJR13AY 2009 Service Manual page 370

• Make sure that the primary driven gear teeth
and primary drive gear teeth mesh correctly.
• Insert a cross-headed screwdriver into one of
the holes of the clutch housing and primary
driven gear, and then rotate the inner primary
driven gear until both primary drive gears are
aligned. The teeth of both primary driven gears
must be aligned for installation.
2. Install:
• Spacer "1"
TIP
Install the spacer with the two screw holes facing
towards the clutch boss.
3. Install:
• Clutch boss "1"
• Lock washer "2" New
• Clutch boss nut "3"
Clutch boss nut
90 Nm (9.0 m·kg, 65 ft·lb)
TIP
• Install the clutch boss nut with its large inner di-
ameter side facing inward as shown in the illus-
tration.
• While holding the clutch boss with the univer-
sal clutch holder "4", tighten the clutch boss
nut.
Universal clutch holder
90890-04086
YM-91042
4. Bend the lock washer tab along a flat side of
the nut.
5. Install:
• Clutch damper spring seat "1"
• Clutch damper spring "2"
TIP
• Install the clutch damper spring seat with the
white paint mark and the sharp edge "a" facing
outward.
• Install the clutch damper spring as shown in
the illustration.
2
1
a
6. Lubricate:
• Friction plates
• Clutch plates
(with the recommended lubricant)
Recommended lubricant
Engine oil
5-65
CLUTCH