Yamaha FJR13AY 2009 Service Manual page 129

1. Clutch actuator motor lead
2. Clutch actuator sensor lead
3. License plate light lead
4. Tail/brake light assembly lead
5. Seat lock cable
6. Intake air temperature sensor
A. Fasten the clutch actuator motor lead and clutch
actuator sensor lead with the band that is used to
secure the MCU (motor control unit).
B. Make sure that the MCU (motor control unit) is not
resting on top of the storage compartment
projection.
C. Route the tail/brake light assembly lead and
license plate light lead between the rib and the U-
lock holder on the rear fender, making sure that the
leads are not routed on top of the holder.
D. Fasten the tail/brake light assembly lead and
license plate light lead with the holder.
E. Route the tail/brake light assembly lead and
license plate light lead between the ribs on the rear
fender.
F. Route the intake air temperature sensor lead
under the wire harness.
G. Fasten the intake air temperature sensor lead to
the air filter case with the holder.
CABLE ROUTING (FJR13AE)
2-80