Yamaha FJR13AY 2009 Service Manual page 670

YCC-S (Yamaha Chip Controlled-Shift) SYSTEM (FJR13AE only)
Diagnos-
tic code Item
No.
Sh_ _62 Malfunction history
code erasure
• No history
• History exists
Sh_ _63 Clutch actuation op-
eration
TIP
The checking meth-
od for the diagnostic
code (Sh_ _63) can-
not be performed
when any of the fol-
lowing fault codes
are detected.
Sh_ _11, Sh_ _12,
Sh_ _13, Sh_ _15,
Sh_ 16, Sh_ _17,
Sh_ _25, Sh_ _26,
Sh_ _36, Sh_ _37,
and Sh_ _44
Data displayed on
meter (reference
value)
Sh_ _62 —
01–09
• If fault codes are stored in the malfunc-
• First displays Sh_
_62 for 6 seconds,
and then displays
the total number
of malfunctions,
including the cur-
rent malfunction,
that have oc-
curred since the
history was last
erased.
• If there are nine or
more of fault
codes stored in
the malfunction
history, "09" is dis-
played.
Sh_ _63 The clutch actuator can be operated in this
mode.
1. The hand shift select indicator light
2. Set the engine stop switch to "
3. Set the engine stop switch to "
4. If the clutch actuator sensor is malfunc-
8-187
Checking method
tion history, the hand shift select indicator
light will come on.
To erase the history, set the engine stop
switch from " " to " ".
After the history is erased, the hand shift
select indicator light will go off.
comes on when the clutch is engaged.
push the hand shift select button simul-
taneously. The clutch will disengage
and the hand shift select indicator light
will go off.
push the hand shift select button simul-
taneously. The clutch will engage and
the hand shift select indicator light will
come on.
tioning, the hand shift select indicator
light will flash.
" and
" and