Yamaha FJR13AY 2009 Service Manual page 105

1. Wire harness
2. ECU (engine control unit)
3. Tail/brake light
4. Rear turn signal light
5. Tail/brake light assembly lead
6. License plate light lead
7. Seat lock cable
8. Stator coil lead
9. Rear shock absorber spring preload adjusting
cable
10. Rectifier/regulator
11. Rectifier/regulator lead
12. Relay unit
13. Brake light relay
14. ABS ECU coupler
15. Rear wheel sensor lead
16. Rear brake light switch lead
17. Hydraulic unit assembly
18. Lean angle sensor
A. Pass the license plate light lead through the hole in
the rear fender.
B. Route the wire harness to the inside of the seat
lock cable.
C. Route the stator coil lead and rectifier/regulator
lead to the outside of the rear shock absorber
spring preload adjusting cable.
D. Pass the stator coil lead and rectifier/regulator lead
through the guide on the frame.
E. Securely connect the ABS ECU coupler.
F. Secure the plastic band by inserting the projection
on the band into the hole in the rear fender, and
then fasten the wire harness at the positioning tape
with the band.
G. Secure the plastic band by inserting the projection
on the band into the hole in the rear fender, and
then fasten the wire harness with the band.
H. Route the rear right turn signal light lead under the
right tail/brake light bulb socket.
I. Route the tail/brake light assembly lead between
the left tail/brake light bulb socket and the
mounting boss on the tail/brake light assembly.
J. Route the rear right turn signal light lead and right
tail/brake light lead over the left tail/brake light bulb
socket.
K. Route the leads between the left tail/brake light
bulb socket and the rear left turn signal light bulb
socket.
L. Route the tail/brake light assembly lead between
the tail/brake light assembly and its bracket.
CABLE ROUTING (FJR13A)
2-56