Yamaha FJR13AY 2009 Service Manual page 127

1. Spark plug lead #1
2. Spark plug lead #2
3. Front wheel sensor lead
4. Main switch lead
5. Throttle cable (accelerator cable)
6. Throttle cable (decelerator cable)
7. Brake hose (brake pipe/upper joint assembly to
front brake calipers)
8. Brake hose (metering valve to right front brake
caliper)
9. Brake hose (front brake master cylinder to brake
pipe/lower joint assembly)
10. Main fuse
11. Positive battery lead
12. Negative battery lead
13. Fuse box 1 (identified by blue tape on lead)
14. Starter relay
15. Fuse box 2
16. Cylinders-#2/#3 ignition coil connectors (white)
17. Cylinders-#1/#4 ignition coil connectors (black)
18. Spark plug lead #3
19. Coolant temperature sensor
20. Spark plug lead #4
21. Cylinder identification sensor lead
22. O sensor coupler
2
23. Throttle position sensor
24. Fuel hose
25. Fuel pump/fuel sender lead
26. Crankcase breather hose
27. Stator coil lead
28. Intake air pressure sensor
29. Fuel tank breather hose (joint to rollover valve) (for
California only)
30. Joint couplers
A. Fasten the front wheel sensor lead to the wire
harness with a plastic locking tie, making sure to
align the tie with the white tape on the harness.
Face the end of the plastic locking tie forward. Do
not cut off the excess end of the plastic locking tie.
B. Position the plastic locking tie 0
in) from the end of the protective sleeve of the front
wheel sensor lead.
C. Route the throttle cables and brake hoses through
the right opening in the frame.
D. Route the wire harness over the spark plug leads.
E. To cylinder identification sensor
F. To fuel tank
G. Fasten the cylinder identification sensor lead with
the holder on the throttle body.
H. Fasten the fuel pump/fuel sender lead and air
induction system solenoid lead with a plastic
locking tie, making sure that the end of the tie faces
forward. Do not cut off the excess end of the plastic
locking tie.
I. Route the stator coil lead to the inside of the
engine bracket (top) and under the crankcase
breather hose.
J. Route the wire harness (to sub-wire harness)
under the fuel hose connector.
K. Route the fuel pump/fuel sender lead under the
fuel hose connector.
– –
20 mm (0 0.79
2-78
CABLE ROUTING (FJR13AE)
L. Route the fuel tank breather hose (joint to rollover
valve) next to the wire harness and pass it through
the guide. (for California only)
M. Place the joint couplers in the area shown in the
illustration, making sure that they do not protrude
above the wire harness.
N. Route the throttle cables over the main switch lead,
spark plug lead #2, and wire harness, and under
spark plug lead #1.