Table of Contents
Advertisement
25
2. Preparation
Preparing the Audio Input System
Connecting a Microphone to the
MIC IN Connector
You can attach a stereo microphone (available
separately) to the microphone holder of the
viewfinder (available separately).
This section describes an example microphone
attachment.
For the procedure for attaching a microphone holder to
other viewfinders, refer to the manual supplied with each
viewfinder.
1
Loosen the screw and open the
microphone holder clamp.
Microphone holder clamp
[1]
[2]
2
Place the microphone in the microphone
holder.
[1]
Place the microphone in the holder so
that "UP" is at the top.
[2]
Close the microphone holder.
[3]
Tighten the screw.
[2]
[3]
[1]
3
Plug the microphone cable into the MIC IN
connector, then set the AUDIO IN switch
for the channel on which you want to
record the audio from this microphone to
FRONT.
4
Secure the microphone cable with the
cable clamp.
Connecting Microphones to the
AUDIO IN Connectors
You can connect up to two monaural
microphones to the AUDIO IN CH-1/CH-2
connectors, using an optional CAC-12
Microphone Holder.
Supported microphones: ECM-674/678 electret
condenser microphone
For details about attaching the microphone holder and
microphone, refer to the instruction manual of each
product.
Attaching a Wireless Receiver
To use a Sony wireless microphone system,
power the camcorder off and then attach a
wireless receiver.
ˎ DWR-S02DN/DWR-S03D Digital Wireless
ˎ
Receiver
ˎ URX-S03D UHF Synthesized Tuner Unit
ˎ
For details about attaching a wireless receiver, refer to the
instruction manual of each product.
Connecting Line Input Audio
Equipment
1
Connect the audio output connector of
the audio equipment that supplies the
line input signal to the AUDIO IN CH-1 or
CH-2 connector.
2
Set the AUDIO IN selector for the channel
to which the audio signal source is
connected to LINE.
XLR connection automatic detect
function
ˎ With the XLR connection automatic
ˎ
detection function switched off (the factory
default setting): Set the AUDIO IN CH1/CH2/
CH3/CH4 switch to REAR for the channels to
which the audio equipment is connected.
ˎ With the XLR connection automatic
ˎ
detection function switched on: When a
cable is connected to the AUDIO IN CH-1
or CH-2 connector, the input from that
connector is automatically selected for
audio recording, regardless of the setting of
the AUDIO IN CH1/CH2/CH3/CH4 switch.
ˎ When the AUDIO IN selector switch is set to
ˎ
LINE or MIC, the type of audio recorded on
audio channels 3 and 4 does not depend on
the XLR automatic detection function. It is
determined by the switch selection only.
The XLR connection automatic detection
function can be switched on/off using
Maintenance >Audio >Rear XLR Auto in the
setup menu.
[4]
[1]
[2]
[3]
[1]
AUDIO IN CH1/CH2/CH3/CH4 switches
[2]
To AUDIO IN CH-1 or CH-2 connector
[3]
Monaural microphone
[4]
AUDIO IN selector switches
Advertisement
Table of Contents
