Table of Contents
Advertisement
123
8. Saving and Loading User Configuration Data
User Configuration Data
You can save setup menu settings in the
camcorder's internal memory and on SD cards.
This allows you to quickly recall an appropriate
set of menu settings for the current situation.
To save setup data on an SD card, insert a
writable SD card (page 30) into the UTILITY
SD card slot before proceeding.
For details about the settings saved in
each file, see "Items Saved in User Data"
(page 151).
Inserting an SD card (for saving
configuration data)
1
Open the switch cover.
2
Insert the SD card (for saving
configuration data) in the UTILITY SD card
slot.
3
Close the switch cover.
Ejecting an SD card (for saving
configuration data)
1
Open the switch cover.
2
Press the SD card in slightly, then remove
the card.
[Notes]
ˎ If the camcorder is turned off or the SD card is
ˎ
removed while the SD is being accessed, the integrity
of data on the card cannot be guaranteed. All data
recorded on the card may be discarded. Always make
sure the ACCESS indicator is off before turning off the
camcorder or removing the SD card.
ˎ Take caution to prevent the SD card from flying out
ˎ
when inserting/ejecting the card.
The following user data is supported.
User Files
User files save the setting items and data of
the customizable User menu. You can save
up to 64 files on an SD card. By loading this
file into the camcorder memory, you can
customize the setup of the User menu.
ALL Files
ALL files save the configuration data of all
menus. You can save up to 64 files on an SD
card.
[Note]
Device specific data (shading, output levels, and other
data that requires adjustment for the specific device) is
not saved.
Scene Files
Scene files save adjustments to Paint menu
items for the purpose of shooting a particular
scene. You can save up to five files in the
camcorder's internal memory and up to 64
files on an SD card.
Scene files allow you to save the following
types of data.
ˎ Values set in the Paint menu
ˎ
ˎ Shutter speeds set in standard mode or ECS
ˎ
mode
ˎ White balance data
ˎ
The data that is saved and loaded depends
on the setting of File >Scene File >Scene
White Data in the setup menu.
Scene files can be stored in internal memory
on the camcorder or on an SD card.
Scene files can also be loaded into the
camcorder.
Reference Files
Reference files save the scene file standard
settings (when File ID is Standard). You can
save one file in the camcorder's internal
memory and one file on an SD card.
Lens Files
You can set the following data for correcting
for the lens characteristics, and save the data
as a lens file. You can save up to 32 lens files in
the camcorder's internal memory and up to 64
lens files on an SD card.
Configuration data
Sub-items
V modulation shading
M V Modulation
correction values
Center marker position
Lens Center H
Lens Center V
Flare level
R Flare
G Flare
B Flare
White balance correction
White Offset R
value
White Offset B
White shading correction
Shading Ch Select
value
Shading H SAW
Shading H PARA
Shading V SAW
Shading V PARA
Gamma Files
You can save up to five user-defined gamma
table data files (User Gamma Data File) in
internal memory.
Advertisement
Table of Contents
