Husqvarna FC 450 Heritage 2023 Owner's Manual page 68

11 SERVICE WORK ON THE CHASSIS
66
–
Position the fork legs.
Air bleeder screw
tioned to the front.
Valve
Info
Grooves are milled into the side of the upper end
of the fork legs. The second milled groove (from
the top) must be flush with the upper edge of the
F03764-10
upper triple clamp.
The air suspension is located in the left fork leg.
The pressure and rebound damping is located in
the right fork leg.
–
Tighten screws
Guideline
Screw, bottom
triple clamp
Z03282-10
–
Tighten screw
Guideline
Screw, top steering
head
Z03284-10
–
Mount and tighten screw
Guideline
Screw, top
steering stem
Z03285-10
–
Using a plastic hammer, tap lightly on the upper triple
clamp to avoid stresses.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Secure the wiring harness with cable holder on the left.
Mount and tighten screw
Z03283-10
3
of the right fork leg is posi-
A
of the left fork leg faces the front.
4
.
M8
2
.
M20x1.5
5
.
M8 20 Nm (14.8 lbf ft)
6
.
M8
7
.
12 Nm (8.9 lbf ft)
12 Nm (8.9 lbf ft)
®
Loctite 243™
17 Nm (12.5 lbf ft)