10 TUNING THE CHASSIS
52
Main work
(All models apart from Rockstar Edition)
–
Remove screws
off the handlebar and lay it to one side.
Info
Cover the components to protect them against
damage.
Do not kink the cables or lines.
–
Remove screws
3
support
Adjusting the handlebar position with the handlebar clamp in
the rubber bearing (All models apart from Rockstar Edition)
–
Position the rubber bushings
–
Place the handlebar support in the required position.
Info
The handlebar support is longer and higher on one
side.
A01169-10
–
Mount and tighten the screws
Guideline
Screw, handle-
bar support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned
correctly.
–
Position handlebar clamp
–
Mount screws
–
First bolt the handlebar clamp with screws
longer, higher side of the handlebar supports so that both
parts touch.
–
Tighten screws
Guideline
Screw, handlebar
clamp
1
. Take off handlebar clamp
7
6
and bushing
. Take off handlebar
.
4
5
and
7
with bushing
M10
40 Nm (29.5 lbf ft)
2
.
1
, but do not tighten yet.
1
evenly.
M8
20 Nm (14.8 lbf ft)
2
. Take
.
6
.
®
Loctite
243™
1
onto the