Table of Contents
Advertisement
Installation: Ceiling Fed Deluge Head
Fix Deluge Head to the ceiling at a convenient height for all the family. Position so that water
sprays down over the centre of the bath, or away from the opening of a shower cubicle. The
fitting of the Deluge Head into the ceiling will be easier with two persons. When you are
working within the bath or shower tray area use a towel or blanket to protect the surface
from damage.
1
Decide on a suitable position for the Ceiling-Fed Arm avoiding cables and pipes
hidden between joists or rafters.
Note: Make sure that the deluge head is not installed over the handshower.
Note: A timber noggin or plywood plinth securely fixed to the joist should be
used to mount the Ceiling-Fed Arm.
Deluge
Head
2
Push the brass pipe through the
ceiling mount plate then push the
threaded end of the brass pipe down
through the hole made in the ceiling.
Drill 29 mm
diameter hole
Caution! Drill
holes in line.
Ceiling Mount
Plate
Brazed Pipe
3
Centralise the brass pipe in the hole
then screw the ceiling mount plate to
the wooden support.
Timber noggin or
plywood plinth
30
Advertisement
Table of Contents
