Table of Contents
Advertisement
Installation: Bath Filler
1
2
Note: Ensure the screws are not cross threaded and are tightened evenly. Hand
tighten only. DO NOT use a power driver to tighten the screws.
Important! When installing the Mixer Valve to be used as a bath filler ensure
the flow rate of the bath overflow fitted exceeds the flow rate output from the
Mixer Valve.
Push Fit Fitting
Check alignment and
retighten the jubilee clip.
Check for leaks
Overflow
Hose
Fixing
Plate
40
Jubilee Clip
Screws
Filler
Head
Note: When the bath filler waste is
extended, there may be a need to rotate
the bodies to allow alignment to the
mating surface.
Refer below steps:
• Loosen the jubilee clip at the overflow
end.
• Rotate the overflow body.
Carefully follow the below assembly drawings
to install the overflow bath filler and waste.
Filler Body
Note: Before removing filler
head remove push fit blanking
cap in push fit fitting.
Gasket
Blanking
Plug
Protective Cover
(DO NOT install)
Advertisement
Table of Contents
