Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers as shown in Figure 29 to
match the closest height-of-cut position.
G010233
3
1
1. Anti-scalp roller
2. Bolt
4
2
Figure 29
3. Flange Nut
4. Hole spacing
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
To adjust, move the lever sideways to unlock seat (Figure 30).
G008962
Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or lower for
maximum operator comfort.
1. Remove the 2 bolts and 2 washers holding the control
lever to the control arm shaft (Figure 31).
2. Move the control lever to the next set of holes. Secure
the lever with the 2 bolts and 2 washers (Figure 31).
27
Figure 30