Inspecting The Belts; Replacing The Mower Belt - Toro TITAN MX5480 Operator's Manual

1. Blades front to rear
2. Outside cutting edges
Leveling the Mower Deck
1. Set anti-scalp rollers to top holes or remove completely
for this procedure.
2. Set the height-of-cut lever to the 76 mm (3 inch)
position.
3. Place two 6.66 cm (2-5/8 inch) blocks under each
side of the front edge of the deck, but not under the
anti-scalp roller brackets.
4. Place two 7.30 cm (2-7/8 inch) thick blocks under the
rear edge of the cutting deck skirt; one on each side
of the cutting deck.
1
1. Wood block, 2-5/8 inch
(6.66 cm) thick
2. Wood block, 2-7/8 inch
(7.30 cm) thick
5. Loosen the leveling adjust locking nuts (item 3) on all
four corners so that the deck is sitting securely on all
four blocks.
Figure 63
3. Measure from the tip of the
blade to the flat surface
here
2
G010336
3
Figure 64
3. Front edge
Note: Make sure that the deck hangers are all the way
down (at the top of the slot) and the deck lift foot lever
is pushed back against the stop (Figure 65).
6. Tighten the four leveling adjust locking nuts (Figure 65).
2 3
1
4
1. Deck lift arm
2. Deck hanger
7. Check that the blocks fit just snugly under the deck
skirt. Make sure all attachment bolts are tight
8. Verify the deck is level by checking the side-to-side
level and front-to-rear blade slope; repeat the deck
leveling procedure if necessary.

Inspecting the Belts

Service Interval: Every 50 hours
Check the belts for squealing when the belt is rotating, blades
slipping when cutting grass, frayed belt edges, burn marks and
cracks are signs of a worn mower belt. Replace the mower
belt if any of these conditions is evident.

Replacing the Mower Belt

Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks are
signs of a worn mower belt. Replace the mower belt if any of
these conditions is evident.
WARNING
The spring is under tension when installed and can
cause personal injury.
Be careful when removing the belt.
47
2 3
1
4
G010321
Figure 65
3. Leveling adjust locking nut
4. Slot in deck hanger