50in Recycler
TimeCutter
Model No. 79024
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Right-hand baffle assembly
Left-hand baffle assembly
Flanged kicker
Recycler bracket
Self-tapping screw
Flange nut (5/16 inch)
Carriage bolt (5/16 x 3/4 inch)
Decal
Mulching blade
No parts required
Installing the Recycler® Kit
1. Stop the engine and remove the ignition key.
2. Remove the mower deck as described in your
Operator's Manual.
3. Turn the mower deck upside down.
4. Remove the existing mower blades installed on your
mower deck.
Note: Refer to the Removing the Blades section in
the Operator's Manual for more information.
5. Remove any debris and grass clippings from the
underside of the mower deck.
6. Locate the cutoff baffle at the side discharge opening
on the mower deck (Figure 1).
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Kit
®
MX Series Riding Mower
Qty.
1
1
3
1
8
Install the Recycler® Kit.
6
1
1
3
–
Convert the mower deck back to side-discharging.
1. Cutoff baffle (existing)
7. Remove the fasteners that secure the cutoff baffle to
8. Install the fasteners into the same holes in the mower
Register at www.Toro.com.
Installation Instructions
Use
1
Figure 1
the mower deck and remove the cutoff baffle.
Note: Save the cutoff baffle for converting back to
side discharge.
deck from which they were originally removed.
Note: This ensures that no holes are left open when
you operate the mower deck.
Form No. 3371-676 Rev B
G018016
Original Instructions (EN)
Printed in the USA
All Rights Reserved