Completing The Setup - Toro TITAN MX5480 Operator's Manual

3

Completing the Setup

Parts needed for this procedure:
1 Ignition Key
1 Hose coupling
1 Operator's Manual
1 Engine Operator's Manual
1 Operator Training Material
Procedure
Setting Up the Motion Control Levers
If needed, remove the upper bolt, washer and nut and raise
the motion control levers to the upright position. Secure the
motion control levers. Refer to Adjusting the Motion Control
Levers in the Operation Section.
Raising the ROPS
Raise the ROPS into the upright position and secure it in
place. Refer to Using the Rollover Protection System (ROPS)
in the Operation Section.
Checking the Tire Pressure
Check the front and rear tires for proper inflation. Refer to
Checking the Tire Pressure in the Operator's Manual for the
recommended inflation pressure.
Checking the Side Discharge Chute
Remove the packing restraint holding the side discharge chute
up and lower the chute into place.
Checking the Engine Oil Level
Before you start the engine and use the machine, check the
oil level in the engine crankcase; refer to Checking the Oil
Level in the Operator's Manual.
Checking the Hydraulic Oil Level
Before you start the engine and use the machine, check the
hydraulic oil level in the reservoir behind the seat; refer to
Checking the Oil Level in the Operator's Manual.
Review the Remaining Parts
Keep all the following items with the machine:
•
Ignition Key
•
Hose coupling
•
Operator's Manual
•
Engine Operator's Manual
•
View the Operator training material before operating the
machine.
15