Premaintenance
Procedures
Raising the Seat
Make sure the motion control levers are the neutral lock
position and parking brake is set. Lift and hold the lever
behind the seat forward to disengage the seat latch and then
lift the seat forward.
The following components can be accessed by raising the seat:
•
Service decal
•
Fuses
•
Battery and cables
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all lubrication
points.
Grease Type: No. 2 General Purpose Lithium Base Grease
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the neutral
position, set the parking brake, stop the engine, remove
the key, and wait for all moving parts to stop before
leaving the operating position.
3. Clean the grease fittings (Figure 33 and Figure 34) with
a rag. Make sure to scrape any paint off of the front
of the fitting(s).
1. Front caster tire
4. Connect a grease gun to each fitting (Figure 34 and
Figure 33). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5. Wipe up any excess grease.
33
1
G009949
Figure 34