Setup; Connecting The Battery; Completing The Setup - Toro 74840 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1

Connecting the Battery

No Parts Required
Procedure
1. Locate the battery and negative battery cable in the
center of the machine.
2. Remove the black plastic cap from the negative
battery post. Remove the fasteners from the negative
battery cable and use them to secure the negative
battery cable to the negative battery post (Figure 4).
4
3
2
1
1. Bolt
2. Washer
3. Negative battery cable
Description
No parts required
Ignition Key
Hose coupling
Operator's Manual
Engine Operator's Manual
Operator Training Material
5
G010257
Figure 4
4. Negative battery post
5. Nut
Qty.
–
Connect the battery.
1
1
1
Complete the Setup.
1
1
2

Completing the Setup

Parts needed for this procedure:
1 Ignition Key
1 Hose coupling
1 Operator's Manual
1 Engine Operator's Manual
1 Operator Training Material
Procedure
Checking the Tire Pressure
Check the front and rear tires for proper inflation. Refer
to Checking the Tire Pressure in the Operator's Manual
for the recommended inflation pressure.
Checking the Side Discharge Chute
Remove the packing restraint holding the side discharge
chute up and lower the chute into place.
Checking the Engine Oil Level
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Checking
the Oil Level in the Operator's Manual.
Checking the Hydraulic Oil Level
Before you start the engine and use the machine, check
the hydraulic oil level in the reservoir behind the seat;
refer to Checking the Oil Level in the Operator's Manual.
Checking the Mower Adjustment
13
Use