Table of Contents
Advertisement
LRI6E LOG SET INSTALLATION
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*For Touch Ups: Satin Black paint is included for burner, and Dark Brown Paint is included for log set,
1
Rear Centre Log
2
Left Side Log
3
Left Front Cross Log
4
Right Center Log Piece
5
Right Front Log
6
Right Upright Log
Important: The ceramic burner supports must be removed prior to installa-
tion of the log set. Remove 4 screws securing the burner supports as shown.
The 2 screws removed from the back wall must be put back into place.
The burner supports along with the remaining screws can be recycled.
A top bracket must be installed prior to installing the log set.
1. Loosen 3 screws on the bottom bracket (see below for location).
2. Slide the top bracket over the screws, retighten the screws.
Top Bracket
3. Place Log 1 so it is positioned perpendicular to the floor of the burner
- see below
919-415a
LOG INSTALLATION
Screw Locations
Log 1 in position
2
4. Place Log 2 on the burner and rest against Log 1 as shown below.
2
Log 2 in position
5. Place Log 3 near the end of Log 2, rest the indent in Log 3 into the
profile in the burner as shown below.
1
LRI6E / HRI6E-11 Direct Vent Gas Insert
LRI6E
installation
1
6
3
4
1
3
06/24/20
5
| 35
Advertisement
Table of Contents
