Table of Contents
Advertisement
installation
OPTIONAL ARCHED VIGNETTE FACEPLATE INSTALLATION
1. Shut off unit and allow to return to room temperature
Note: The remote control receiver located on the lower left hand side of the
appliance should be in the remote position prior to installing this faceplate.
The CPI (continuous pilot ignition) switch also located on the lower left
hand side, if choosing to keep the pilot on at all times, should also be
completed at the same time prior to installing this faceplate.
2. Install 4 supplied screws (loosely) onto unit in locations shown below.
Keyholes on inner
Vignette frame
3. Install the inner Vignette frame by hanging the frame off the 4 screws
via the keyhole openings on the frame. When in position, tighten the
4 screws.
4. Install the safety screen into the inner Vignette frame by slightly tilting
the safety screen frame and placing it up into the Vignette frame. Let the
safety screen slightly drop down into position within the Vignette frame.
Install safety screen
919-911
46 |
LRI6E / HRI6E-11 Direct Vent Gas Insert
LRI6E / HRI6E / LRI4E / HRI4E OPTIONAL ARCHED VIGNETTE FACEPLATE
tooltip
tooltip
Install 4 screws
onto unit
tooltip
tooltip
5. Install the outer Vignette frame onto the inner Vignette frame by hanging
tabs into slots on inner Vignette frame. The bottom of the outer faceplate
will be held in position by magnets.
Install outer Vignette frame onto
inner Vignette frame
Completed Install
Completed Install
Decorative Arch
09.21.18
Advertisement
Table of Contents
