Overriding the Default Monitor Mode | 81
res="1024x768 @ 70Hz"
This line indicates that your monitor's resolution (pre-adjusted
timing name) is 1024 x 768 @ 70Hz.
When modifying the
line, use the exact name for your
res
monitor from the "Pre-Adjusted Timing Name" column in
the Resolutions and Refresh Rates table on pages 97 and 98.
monitor="domecolr.vda"
This line indicates that you are using a color monitor, and
the pre-adjusted timing name is located in the monitor file
.
domecolr.vda
Monitor files are located in the
/opt/DOMEmd2pci/monitors
directory. Do not modify these files unless DOME Support
advises you to do so.
To support a grayscale monitor, use
in place
"domegray.vda"
of
"domecolr.vda".
board="md2pci-2hd.xqa"
This line indicates that you are using two heads (
) of an
-2hd
Md2/PCI board (md2pci), and that the board configuration
is located in the board file, md2pci-2hd.xqa.
Board files are located in the
/opt/DOMEmd2pci/boards
directory. Do not modify these files.
See the second code sample on page 79 for the second head.
Both heads of the same board must use the same resolution.