Table of Contents
Advertisement
Installation order
Follow these steps to install the Md2/PCI board and its driver on
a PC or a Sun PCI workstation.
1.
Set jumper J4 on the board.
2.
Install the board.
3.
Connect the monitor to the board.
4.
Install the driver.
Use this table to locate installation instructions for your
operating system.
To...
Set
jumper J4
Install
board
Connect
monitor
Install
driver
Windows 2000,
go to...
"Disabling VGA
mode" on page 8
"Installing the
Md2/PCI Board" on
page 10
Instructions for
your monitor
"Installing the PCI
Windows 2000
Driver" on page 14
Installation Requirements | 5
Windows NT 4.0,
go to...
"Disabling VGA
mode" on page 8
"Installing the
Md2/PCI Board" on
page 10
Instructions for
your monitor
"Installing the PCI
Windows NT 4.0
Driver" on page 42
Solaris 2.5.1 or
later, go to...
"Disabling VGA
mode" on page 68
"Installing the
Md2/PCI Board" on
page 69
Instructions for
your monitor
"Installing the PCI
Solaris Driver" on
page 74
Advertisement
Table of Contents
