Table of Contents
Advertisement
32 | Installing the Board and Driver in a PC
10.
11.
To remove modes
1.
2.
3.
Click Save Mode -> OK to save the mode.
If your edits result in a new mode (that is, the X, Y, BPP, and
refresh rate is not already included in the configuration file),
the control panel adds the new mode to the
If your edits result in a refresh rate that matches the whole-
number value of an existing refresh rate for an existing
resolution, the mode corresponding to the new refresh rate
overwrites the mode corresponding to the existing refresh
rate in the
.dom
For example, assume you are editing a mode of
1024 x 768 x 8 with a refresh rate of 70.08 Hz. If
you make changes that result in a new refresh
rate of 70.4 Hz, 1024 x 768 x 8 @ 70.4 Hz replaces
1024 x 768 x 8 @ 70.08 Hz when you save the mode.
Click OK to close the Display Properties dialog box, and
Restart your computer.
You must restart your computer to activate the new
mode. The device driver cannot recognize changes to
the configuration file until you restart.
Highlight the resolution for the mode you want to remove,
and click Remove Mode. (You can remove any mode except
the current mode.)
A dialog box asks whether you are sure you want to
remove the mode.
Click Yes to remove the mode, or No to cancel.
Click OK to close the Display Properties dialog box, and
Restart your computer.
The change takes effect after you restart the computer.
file.
file.
.dom
Advertisement
Table of Contents
