Table of Contents
Advertisement
32. Reinstall the I/O bracket. See "Replacing the I/O bracket" on page 89.
33. Reinstall the system board. See "Replacing the system board" on page 108.
34. Reinstall the heat sink assembly. See "Replacing the heat sink" on page 106.
35. Reinstall the Wi-Fi card. See "Replacing the Wi-Fi card" on page 105.
36. Reinstall the Wi-Fi antennas. See "Replacing the Wi-Fi antennas" on page 96.
37. Reinstall the VESA mount bracket. See "Replacing the VESA mount bracket" on page 99.
38. Reinstall the cover presence switch. See "Replacing the cover presence switch" on page 98.
39. Reinstall the system board shield. See "Replacing the system board shield" on page 97.
40. Reinstall the Orchid Tilt Stand. See "Replacing the Orchid Tilt Stand" on page 92.
41. Reinstall the storage drive. See "Replacing the memory module" on page 87.
42. Reinstall the bottom cover. See "Replacing the bottom cover" on page 86.
43. Reinstall the memory module. See "Replacing the memory module" on page 87.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 117.
Completing the parts replacement
After completing the installation or replacement for all parts, reinstall the slide cover and reconnect cables.
Depending on the parts you installed or replaced, you might need to confirm the updated information in the
Setup Utility program. Refer to "Using the Setup Utility program" on page 59.
To reinstall the slide cover and reconnect cables to your computer, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are
left inside your computer. See "Computer components" on page 31 for the locations of various
components in your computer.
2. Ensure that the cables are routed correctly before reinstalling the slide cover. Keep cables clear of the
hinges and sides of the computer chassis to avoid interference with reinstalling the slide cover.
3. Align the sides of the slide cover with the corresponding rail guides on the computer. Then, slide
the cover as shown until it snaps into position.
Figure 61. Installing the slide cover
.
Chapter 9
Installing or replacing hardware
117
Advertisement
Table of Contents
