Table of Contents
Advertisement
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the slide cover is facing up.
3. Remove the slide cover. See "Removing the slide cover" on page 85.
4. Remove the bottom cover. See "Replacing the bottom cover" on page 86.
5. Remove the two screws that secure the Orchid Tilt Stand to remove it from the computer.
Figure 23. Removing the Orchid Tilt Stand
6. Rotate the screw
1
that secures the Orchid Tilt Stand base to remove it from the Orchid Tilt Stand.
Figure 24. Removing the Orchid Tilt Stand base
7. Insert the metal stud on the Orchid Tilt Stand into the Orchid Tilt Stand base. Then, rotate the screw
to secure the new Orchid Tilt Stand base.
Figure 25. Installing the Orchid Tilt Stand base
.
Chapter 9
Installing or replacing hardware
1
93
Advertisement
Table of Contents
