Replacing The Orchid Tilt Stand - Lenovo 10HU Hardware Maintenance Manual

8. Remove the two screws that secure the card reader to remove it from the I/O board.
Figure 21. Removing the card reader
9. Align the two screw holes in the new card reader with the corresponding holes in the I/O board. Then,
install the two screws to secure the card reader to the I/O board.
Figure 22. Installing the card reader
10. Connect the card reader cable to the card reader connector in the I/O board.
11. Reinstall the I/O shield. See "Replacing the I/O shield" on page 90.
12. Reinstall the I/O bracket. See "Replacing the I/O bracket" on page 89.
13. Reinstall the bottom cover. See "Replacing the bottom cover" on page 86.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 117.

Replacing the Orchid Tilt Stand

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the Orchid Tilt Stand, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
92
ThinkCentre X1 Hardware Maintenance Manual